Rear Panel; Rear Panel Components; Rear Panel Component Descriptions; Cartridge Door - IBM TS2900 Setup, Operator, And Service Manual

Rear panel

Figure 5. Rear panel components
Table 5. Rear panel component descriptions
Number Component
1
Power connector
2
Power switch
3
SAS host interface connector
4
Ethernet port
5
Accessor locking screw
6
The library connects to a 110/220 volt ac power supply.
The library is powered ON when the power supply switch on the
rear panel is ON (|). The library has no independent power switch
on the front panel.
Serial-attached SCSI host interface cable connection. The Ultrium 3,
4, 5, 6, and 7 SAS drives use the SFF-8088 connection at the drive
end and SFF-8088 or SFF-8470 at the host adapter end.
This port is used to connect the library to a network.
The accessor locking screw is used to lock the accessor in place
during transportation.
Important: Remove the accessor locking screw before the library is
powered ON.
Air vent These vents allow air to escape from the power supply and tape
drive sled.
3
5 4 1
Description
Product description
2 6
5