Johnson Controls WT-4002-MCR Installation Instructions Manual page 18

2. Use the Up/Down buttons to select Standalone on
the menu (Figure 22).
Standalone
Net Config
Fan Mode
Standalone
Maintenance
Figure 22: Selecting the Stand-Alone Mode
3. Press to confirm the selection.
4. Select Date & Time on the menu (Figure 23) and
press to enter the setup screen.
Standalone
Date & Time
Weekday
Weekend
Figure 23: Selecting Date and Time
5. In the Date & Time menu (Figure 24), press
to highlight the menu options that require editing.
Year 2014
Month 01
Day 01
Hour 01
Minute 01
Figure 24: Setting the Date and Time
6. Press the Up button
to change the value.
-
WT-4000 Series Pneumatic-to-Direct Digital Control (DDC) Room Thermostats Installation Instructions
or the Down button
+
7. Press to confirm the selection.
8. Repeat Step 5 through Step 7 until all of the menu
options are configured correctly. Press the Up
button or the Down button
+
through the date and time menu options.
9. While in the configuration menu, use the Up/Down
buttons to navigate to Weekday to program the
weekday schedule.
10. Press to open the weekday schedule.
11. Set the Weekday 1 schedule (Figure 25), which is
usually the start of the Occupied Mode.
Weekday 1
70
Figure 25: Setting the Weekday 1 Schedule
a. Leave the top line as Weekday 1.
b. Press the Up button
to scroll through the occupancy mode,
-
start time, and lower temperature limit menu
items.
c. Press to open a specific menu item.
d. Press the Up button
to change the value, then press
-
save the setting.
18
to scroll
-
Occupied
07:00
or the Down button
+
or the Down button
+
to