Connecting An External Ir Receiver To The Dhd Controller; External Ir Receiver Connection - Runco Video Xtreme VX-6000d Owner's Operating Manual

Installation
Connecting an External IR
Receiver to the DHD
Controller
Projector: The projector is equipped with an additional 12-volt trigger output. This trigger
activates when the projector is turned on. Connect it to your retractable screen or other,
12-volt trigger-activated equipment as shown in Figure 3-15.
100-240V
AC INPUT
to retractable screen
or other, 12-volt
trigger-activated
equipment
Figure 3-15. 12-volt Trigger Output Connection (from Projector)
If infrared signals from the remote control cannot reach the DHD Controller due to
excessive distance or obstructions such as walls or cabinet doors, you can connect an
external IR receiver to the DHD Controller to extend the range of the remote control. See
Figure 3-16.
Pb Pr
Component Video
IR Receiver
Remote
Control
Figure 3-16. External IR Receiver Connection
When an external IR receiver is connected to the wired IR input, the
Note
built-in IR sensor on the DHD Controller is disabled.
HDMI IN
(cylindrical,
DC power
supply-type
plug)
Sleeve = Ground
Tip = +12V
TRIGGERS
1 2 3 IR
Y S-Video 1
Video S-Video 2 RS-232 Out RS-232 Control
38
+12V WIRED RS-232C
IR
Ring = +5V
Tip = IR Input
Sleeve = Ground
(3.5-mm
mini phono
plug)
Runco VX-6000d Owner's Operating Manual