Quick Setup Guide - Runco Video Xtreme VX-2c Owner's Operating Manual

QUICK SETUP GUIDE

The VX-2c is designed to receive only digital input signals directly from the companion DHD Controller/Processor. All signal
sources should be connected to the appropriate inputs on the rear panel of the DHD. The signal from the DHD is then output
to the VX-2c projector through a Runco Proprietary (RP) DVI cable. Please note that it is NOT POSSIBLE to connect a signal
source with DVI output directly to the VX-2c. It MUST be routed through the DHD for proper operation.
DHD Controller Rear View
Runco Proprietary (RP) DVI Cable
VX-2c Projector Rear View
Follow the steps on page 16 to ensure proper installation of the VX-2c projector and DHD
Controller.
11