Installation
Connecting to AC Power
If your home theater contains a retractable screen, screen mask or other 12-Volt
trigger-activated equipment, connect it to a 12-Volt trigger output as shown in Figure
3-12.
to 12-Volt
trigger-activated
equipment
Figure 3-12. Connecting a 12-Volt Trigger Output to Other Equipment
Plug the female end of the power cord into the AC receptacle on the rear of the VX-2ix
(AC 100V ~ 240V). Then, connect the other end to your AC power source.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to a 110 VAC power
source.
The input voltage to the AutoScope lens motor must be between
Caution
100 and 120 VAC. Do not connect the AutoScope lens motor
to a 200-240 VAC power source!
TRIGGERS
1
2
Pb
Pr
Y
S-Video 1
Component Video
Video
S-Video 2
RS-232 Out
Sleeve = Ground
Tip = +12V
26
3
IR
RS-232 Control
3.5-mm
mini plug
Runco VX-2ix Owner's Operating Manual