Maintenance And Troubleshooting; Lamp Replacement; Lens Replacement - Runco Video Xtreme VX-2ix Owner's Operating Manual

The lamp should be replaced when it reaches the end of its life (typically 2000 hours), or
sooner if a noticeable degradation in brightness occurs. Contact your Runco dealer to
obtain a replacement lamp.
1. Turn off the projector and unplug the power cord. Allow the projector to cool down for
approximately 45 minutes prior to removing the lamp assembly for replacement.
2. Loosen the four rear Lamp Cover
screws and remove the cover.
3. Remove the two lamp assembly mounting screws.
4. Grasp the lamp assembly handle and pull gently, removing the lamp module from the
projector housing.
5. Install the new lamp module.
6. Replace the lamp cover and re-tighten all screws.
7. Reset the Lamp Hour counter. To do this, select Service from the Main Menu, then
Display Device, then Installation. Use the cursor buttons to highlight Reset under
"Lamp Hours" and press ENTER.
If you need to remove the lens – either to replace it or to prepare the projector for
shipment – proceed as follows:
Only trained, authorized Runco dealers should attempt to
Note
remove or replace a lens. Please read this procedure
carefully before doing so.
Lens replacement is normally performed at the Runco factory. Field
replacement of lenses is generally only required if the projector is
re-installed in a new location or the lens has been damaged.
1. Power down the projector and wait five minutes to allow the lamp to cool.
2. Remove the secondary anamorphic lens, if present.
Runco VX-2ix Owner's Operating Manual

5. Maintenance and Troubleshooting

REMOVE THESE SCREWS
45
5.1

Lamp Replacement

5.2

Lens Replacement