Sleep Timer - Runco LIGHTSTYLE LS-10D Installation & Operation Manual

You should save changes to any of the following settings to a preset; otherwise they will
be lost when a new input source or resolution is selected:
• Brightness
• Contrast
• Color saturation
• Tint
• Sharpness
• Gamma
• Lamp Settings
• Color temperature and white balance
To select a memory preset, press
To save the settings for the current input and display mode to the Custom 1 or Custom 2
memory preset, select it, press
To save the settings for the current input and display mode to the
Note
ISF Night or ISF Day memory preset, select Save ISF Night or Save
ISF Day from the Calibration menu (refer to Save ISF Night/Save
ISF Day on page 63).
To reset the Custom 1 or Custom 2 memory preset to its factory-default state, select it,
press or to highlight Reset and press ENTER.
Select Sleep Timer from the Main Menu to turn off the LS-10d after a specified interval.
Press or to select Off, 30 Minutes, 60 Minutes, 90 Minutes, 2 Hours or 4 Hours.
Then, press ENTER.
Runco LS-10d Installation/Operation Manual
or to highlight it and press ENTER.
or to highlight Save and press ENTER.
57
Operation

Sleep Timer

Sleep Timer
Off
30 Minutes
60 Minutes
90 Minutes
2 Hours
4 Hours