Siemens SIMATIC NET SCALANCE S615 Configuration Manual page 63

● "Syslog Client" check box
Enable or disable the Syslog client. You can configure other settings in "System > Syslog
Client".
● "DCP Server" drop-down list
Specify whether or not the device can be accessed with DCP (Discovery and
Configuration Protocol):
– "-" (disabled)
– Read/Write
– Read-Only
● "Time"drop-down list
Select the setting from the drop-down list. The following settings are possible:
– Manual
– SNTP Client
– NTP Client
– SIMATIC Time
● "SNMP" drop-down list:
Select the protocol from the drop-down list. The following settings are possible:
– "-" (SNMP disabled)
– SNMPv1/v2c/v3
– SNMPv3
● "SNMPv1/v2 Read-Only" check box
Enable or disable write access to SNMP variables with SNMPv1/v2c.
SCALANCE S615 Web Based Management
Configuration Manual, 05/2015, C79000-G8976-C388-02
DCP is disabled. Device parameters can neither be read nor modified.
With DCP, device parameters can be both read and modified.
With DCP, device parameters can be read but cannot be modified.
The system time is set manually. You can configure other settings in "System >
System Time > Manual Setting".
The system time is set via an SNTP server. You can configure other settings in
"System > System Time > SNTP Client".
The system time is set via an NTP server. You can configure other settings in "System
> System Time > NTP Client".
The system time is set using a SIMATIC time transmitter. You can configure other
settings in "System > System Time > SIMATIC Time Client".
Access to device parameters via SNMP is not possible.
Access to device parameters is possible with SNMP versions 1, 2c or 3. You can
configure other settings in "System > SNMP > General".
Access to device parameters is possible only with SNMP version 3. You can configure
other settings in "System > SNMP > General".
Configuring with Web Based Management
4.4 "System" menu
63