Siemens SIMATIC NET SCALANCE S615 Configuration Manual page 161

– manual (With Standard)
● Remote Address
– In standard mode, enter the WAN IP address or the DDNS hostname.
– In Roadwarrior mode, you can enter an IP range from which connections will be
● Remote Subnet
Enter the remote subnet of the remote station. Use the CIDR notation. Can only be edited
if "Remote Type" "manual" is enabled.
● Virtual IP Mode
Specify whether or not the remote station is offered a virtual IP address.
The following options are available:
– user defined IPv4
– none
● Virtual IP
Specify the subnet (CIDR) from which the remote station is offered a virtual IP address.
Can only be edited if "Virtual IP Mode" "user defined IPv4" is enabled.
Procedure
Configure VPN standard mode
1. Enter the name of the partner in "Remote End Name".
2. Click the "Create" button. A new entry is generated in the table.
3. For "Remote Mode", select "Standard".
4. For "Remote Type", select "manual".
5. In "Remote Address", enter the WAN IP address and in "Remote Subnet" the subnet of
the partner.
6. Click the "Set Values" button.
Configure VPN Roadwarrior mode
1. Enter the name of the partner in "Remote End Name".
2. Click the "Create" button. A new entry is generated in the table.
3. For "Remote Mode", select "Roadwarrior".
4. For "Remote Type", select "any".
5. In "Remote Address", enter the IP address of the remote network.
SCALANCE S615 Web Based Management
Configuration Manual, 05/2015, C79000-G8976-C388-02
Only establishes a connection to a specific remote station with a fixed IP address or
with (D)DNS hostname.
Or only accepts a connection from a specific remote station with a fixed IP address or
with (D)DNS hostname.
accepted. 0.0.0.0/0 means all IP addresses are accepted.
The virtual IP address is from the band specified in "Virtual IP".
No virtual IP address. The VPN tunnel is established dynamically to the internal IP
address of the remote station.
Configuring with Web Based Management
4.8 "Security" menu
161