Preparing the Machine for Use
2.
Attach the automatic correction jig.
Push down on the screw heads to open the workpiece installation section.
If force is applied in the direction of the back of the machine when you push down on the screw
heads, the rotary axis may move.Forcefully moving the rotary axis by hand is forbidden, but there is
no problem if you have to move it slightly in this manner.
However, do not move the rotary axis by hand multiple times or apply excessive force to move the
rotary axis.
40
Loosen the screws about 3 turns using a
torque driver. (2 locations)
Open this section.