1. Loosen and remove bolts D, front tie–down clamp B (if
installed) and spacer A at front position.
2. Loosen and remove bolt E, spacers F + G, rear
tie-down clamp (not shown), washer H, nut I and end
cap J at rear position. When removing take care on
battery rail C. Completely withdraw bolt Eto remove
rear tie down clamp and spacers.
3. Install new parts in reverse order.
4. Test all functions.
5.6.6 Replacing Curb Climber
CAUTION!
Risk of crushing
Injury hazard to hands. The gas spring is under
pressure.
– Be careful with your hands.
– Use suitable tools.
•
4 mm Allen key
•
10 mm Allen key
•
10 mm wrench
•
13 mm wrench (2x)
•
19 mm wrench
When removing, take care of small parts such as
screws and washers. Put all small parts down so that
they can be installed in correct sequence.
Removing Curb Climber
1. Secure mobility device against rolling away.
2. If necessary, remove parts that are in the way like
legrests.
1441763-E
Fig. 5-5
3.
Loosen and remove nut A and washer B.
4. Secure gas spring C! Pull bolt F and washer E out
of holder D.
5.
Loosen and remove nut A including washer B.
6. Pull bolt D out of holder.
7. Remove curb climber F including bushing E from
mounting bracket C.
8.
Hold in place bolt E. Loosen and remove nut A
including washer B.
9. Replace gas spring C.
Fig. 5-6
Fig. 5-7
Fig. 5-8
Service
17