Replacing Manual Wheel Lock; Repairing Tire Puncture (Drive Wheel) - Invacare Mirage Service Manual

1.
Apply retaining compound circular on leading edge
of shaft and thread locking adhesive into threaded
mounting hole of shaft.
2.
Apply retaining compound circular on inner surface of
hub.
3. Shift hub on shaft twice to thoroughly spread retaining
compound.
4. Remove excessive retaining compound with a cloth.
Avoid contact of compound with rim painting.
5. Install the wheel again.
6. Apply thread locking adhesive on center screw.
7. Insert countersunk center screw including washer and
tighten with 30 Nm.
8. Affix label on center screw.
9. Allow adhesives to cure for approximately 30 minutes.
Do not drive under load during this time.

5.8.6 Replacing Manual Wheel Lock

• 4 mm Allen key
• 5 mm Allen key
1. Disengage wheel lock D.
2. Loosen Anti-rotation screw A.
3. Loosen clamp screws C and remove wheel lock D and
clamp from side frame B.
1441763-E
Fig. 5-14

5.8.7 Repairing tire puncture (drive wheel)

CAUTION!
Risk of injury if mobility device starts moving
unintentionally during repair work
Switch power supply off (ON/OFF key).
– Engage drive.
– Before raising mobility device, secure wheels by
blocking them with wedges.
CAUTION!
Risk of crushing to hands and feet by weight of
mobility device
– Pay attention to hand and feet.
– Use proper lifting techniques.
• Torque wrench with
– Torx-Bit TX40
• 5 mm Allen key
• Mounting kit
• Wooden block (approx. 12 x 12x 30 cm for
propping up mobility device)
• Repair kit for tire repair or a new inner tube
• Talcum powder
Removing wheel
1. Lift mobility device up and place wooden block
underneath it to keep it in raised position.
2.
Remove four countersunk head screws TX40 (1) using
Torx bit.
3. Pull wheel from hub.
Repairing flat tire
WARNING!
Risk of explosion
There is considerable pressure in tire. Risk of
injury if you do not deflate tire before removing
wheel rim.
– Press in tappet and deflate tire.
1. Remove valve cap.
2. Pressing in tappet and deflate tire.
3.
Remove 5 screws (2) on reverse side of wheel.
4. Remove rim halves from tire.
5. Remove inner tube from tire.
Service
21