Chassis; Removing Chassis Components - Invacare Mirage Service Manual

Fault
Description
Code
8
Power module error
9 Remote Communications
Fault
10
Unknown error
11
Incompatible remote

5.6 Chassis

5.6.1 Removing Chassis Components

• 4 mm Allen key
• 5 mm Allen key
• 8 mm wrench (2x)
• 10 mm wrench (2x)
• 13 mm wrench (2x)
• 17 mm wrench (2x)
• Flat screwdriver
• Mallet
1441763-E
Sub
Notes
Code
00
Power Module Fault
01
RAM fault
02 ROM fault
03 CPU fault
04
EEPROM fault
05
Watchdog fault
06
Stack fault
07
Software fault
08 Power up testing fault
09 Relay fault or Pre-charge fault
0A
Bridge fault or Disable all fault
0B
Electronics fault
0C
Calibration settings fault
00
Loss of communications between remote and power module
01 Limp mode due to unreliable communications
00
Catch all fault output
00
Wrong remote type is connected. Ensure that the power module type
code matches the remote type code.
Fig. 5-1
1. Remove parts that are in the way, such as batteries,
armrests, legrests, and anti-tippers. Removing wheels
and motors is optional.
Batteries
See corresponding user manual.
Backrest See 5.11.1 Replacing Backrest
Unit, page 25.
Legrest
See 5.14 Footrests / Legrests,
page 27.
armrest
See 5.13 Armrests, page 26.
Anti-Tipper
See 5.8.8 Replacing Anti-Tipper,
page 22.
Propulsion unit See 5.7.1 Replacing Motor, page
18.
Curb climber See 5.6.6 Replacing Curb Climber,
page 17.
Castor wheels See 5.8.2 Replacing Castor Wheels,
page 19.
Drive wheels See 5.8.4 Replacing drive wheel,
page 20.
2. If seat clamp (7) is locked, unlock both right and left
hand side and fold wheelchair frame.
3. Remove legrest holder. See 5.14.1 Replacing Legrest
Holder, page 27.
4. Remove plastic frame fittings (12) carefully.
5. Remove X-Brace and seat stays. See 5.6.3 Replaxing
X-Brace, page 16.
6. Remove battery rails. See 5.6.5 Replacing Battery Rails,
page 16.
7. Remove rear seat saddles (6). See 5.6.2 Replacing Seat
Saddles, page 16.
Service
15