H-Activity On / Off; Usb Midi Driver Mode; Startup Memory; Factory Reset - Roland Edirol PCR-1 Owner's Manual

H-ACTIVITY ON / OFF (Keyboard : 5)
fig.hyo
Perform steps 1-3.
4. Use the [DEC] [INC] buttons or the [0] or [1] keys to switch H-ACTIVITY
ON / OFF.
The display will indicate either "ON" or "OFF".
5. Press the [ENTER] button.
USB MIDI DRIVER MODE (Keyboard : 6)
Perform steps 1-3.
4. Use the [DEC] [INC] buttons or the [0] or [1] keys to specify the USB MIDI DRIVER
MODE.
0
1
* FPT = Fast Processing Technology for MIDI Transmission:
Effective use is made of the USB bandwidth according to the amount of MIDI data to be transmitted,
ensuring that MIDI data processing will always occur optimally.
5. Press the [ENTER] button.
STARTUP MEMORY (Keyboard : 7)
Perform steps 1–3.
4. Use the [DEC] [INC] buttons or the [0] or [1] keys to specify the GM2/LAST ACCESS
MEMORY setting.
0
1
5. Press the [ENTER] button.
FACTORY RESET (Keyboard : 8)
Perform steps 1–3.
fig.rst
4. The display will indicate "RST".
fig.yes
5. Press the [ENTER] button.
The display will blink "YES".
6. Press the [ENTER] button.
FPT technology is used to perform high-speed MIDI trans-
Original driver
fer. Normally, we recommend that you use this mode.
Select this if you are using the standard MIDI driver provid-
Generic driver
ed by your operating system.
When the PCR starts up, memory number 0 (GM2) will
GM2 MEMORY be loaded into current memory (p. 88) regardless of the
state in which the power was turned off.
LAST ACCESS Upon power-up, the PCR-1 will recall the memory that
MEMORY was last recalled or saved into current memory (p. 88).
System settings
0 OFF
ON
1
95