Using The Cutting-Unit Kickstand; Replacing The Warning Decal For Ce Compliance - Toro Reelmaster 5510-D Operator's Manual

5
Using the Cutting-Unit
Kickstand
Parts needed for this procedure:
1 Cutting-unit kickstand
Procedure
Whenever you need to tip the cutting unit to expose
the bedknife/reel, prop up the rear of the cutting unit
with the kickstand to make sure that the nuts on the
back end of the bedbar-adjusting screws are not
resting on the work surface
Figure 15
1. Cutting-unit kickstand
Secure the kickstand to the chain bracket with the
snapper pin (Figure 16).
(Figure 15).
g003985
1. Chain bracket
2. Snapper pin
6
Replacing the Warning
Decal for CE Compliance
Parts needed for this procedure:
1 Warning decal
Procedure
On machines requiring CE Compliance, affix the CE
warning decal (Part No. 133-2931) over the standard
warning decal (Part No. 133-2930).
15
Figure 16
3. Cutting-unit kickstand
g004144