Replacing The Hydraulic Filters; Checking The Hydraulic Lines And Hoses - Toro Reelmaster 5510-D Operator's Manual

Replacing the Hydraulic
Filters
Service Interval: Every 800 hours (Or more often if
the service-interval indicator is in
the red zone).
The hydraulic system is equipped with a
service-interval indicator
engine running at operating temperature, view the
indicator, it should be in the green zone. When the
indicator is in the red zone, change the hydraulic
filters.
Figure 101
1. Hydraulic-filter-restriction indicator
Important:
Use of any other filters may void the
warranty on some components.
1. Position the machine on a level surface, lower
the cutting units, shut off the engine, engage
the parking brake, and remove the key from the
ignition switch.
2. Clean the area around the filter-mounting area
and place a drain pan under the filter
102) and (Figure
Figure 102
1. Hydraulic filter
(Figure 101). With the
(Figure
103).
1. Hydraulic filter
3. Remove the filter.
4. Lubricate the gasket on the new filter with
hydraulic oil.
5. Ensure that the filter-mounting area is clean.
g004132
6. Install the filter by hand until the gasket contacts
the mounting surface, then rotate it an additional
1/2 turn.
7. Repeat the procedure on the other filter.
8. Start the engine and let it run for about 2 minutes
to purge air from the system.
9. Shut off the engine and check for leaks.
Checking the Hydraulic
Lines and Hoses
Service Interval: Before each use or daily
Check the hydraulic lines and hoses for leaks, kinked
lines, loose mounting supports, wear, loose fittings,
weather deterioration, and chemical deterioration.
Make all necessary repairs before operating.
g021271
63
Figure 103
g004150