Setting The Direct Monitor - Roland VG-99 Owner's Manual

Chapter 7 Using the VG-99 Connected to a Computer Via USB

Setting the Direct Monitor

1.
Press [SYSTEM].
2.
Press PAGE [ ] [
3.
Press [F2] (USB).
4.
Press PAGE [ ] to go to Page 2.
5.
Change the setting's value with [F2] (SELECT),
[F3] (OFF/ON) or the F2, F3 knobs.
For more information on signal paths set by the Direct
Monitor parameter settings, refer to "Signal Flow" (p.
183).
6.
Press [EXIT] one or more times to return to the
Play screen.
74
] to go to Page 2.
Parameter/
Explanation
Range
MON CMD (Monitor Command)
This setting determines whether or not the command (the Direct
Monitor command) controlling the Direct Monitor (described later)
setting is enabled.
DISABL The Direct Monitor command is disabled,
maintaining the Direct Monitor mode set by
the VG-99.
ENABLE The Direct Monitor command is enabled, al-
lowing the Direct Monitor mode to be
switched from an external device.
DIRECT MON (Direct Monitor)
Switches the output of the VG-99 sound to the PHONES jack, MAIN
OUT jacks, or SUB OUT jacks.
Audio signal
USB OUT
DIRECT MON
VG-99 sound
MAIN or SUB
OFF Set this to Off if transmitting audio data in-
ternally through a computer (Thru).
ON The VG-99 sound is output. Set this to On
when using the VG-99 as a standalone de-
vice, without connecting to a computer
(only USB IN input sound will be output if
this is set to Off).
* This setting cannot be saved. It is set to ON when the power is turned
on.
* If you are using the special driver, you can control DIRECT MON On/
Off from ASIO 2.0-compatible application.
Computer
Audio IN
Audio OUT
USB IN
Guitar Amp
Headphones
Mixer