ProForm ACTIVATOR V5 User Manual page 9

5. Have a second person hold the Upper Upright
(36) near the Lower Upright (1).
See the inset drawing. Locate the wire tie in
the Upper Upright (36). Tie the lower end of the
wire tie to the Wire Harness (43) as shown.
Then, pull the upper end of the wire tie until the
Wire Harness is routed through the Upper
Upright.
6. Tip: Be careful not to pinch the wires during
this step.
Attach the Upper Upright (36) to the Lower
Upright (1) with four M10 x 20mm Patch Screws
(28) and four M10 Split Washers (38).
7. Tip: Orient the Handlebar (39) so that the
sticker marked with an "R" is in the location
shown.
Attach the Handlebar (39) to the Upper Upright
(36) with two M10 x 62mm Patch Screws (37)
and two M10 Split Washers (38).
5
Wire Tie
43
6
38
28
7
39
36
9
43
36
1
36
28
38
1
37
38
"R"