Appendix A. Cable Drawings; Introduction - Comtech EF Data CRS-280L Installation And Operation Manual

A.1 Introduction
This appendix contains drawings of cables used with the CRS-280 (70/140 MHz) and the CRS-280L (L-Band) IF Switch for 1:N
Redundancy. These cables are broken into two categories – Control Interface Cables and IF Interface Cables:
•
The Control Interface Cables are used to connect the CRS-280L rear panel J1 CRS Control Interface or J2 SMS Control
Interface connector to its companion redundancy switch IF Switch Control Interface connector.
•
The IF Interface Cables may be selected and used to connect the CRS-280L, via the front panel Tx/Rx Type 'N'
threaded female connectors, to the Redundant Modem and up to 10 traffic modems that are part of the 1:N redundancy
setup, as well as to any external uplink / downlink RF equipment.
Each section provides illustrations of the cables' technical specifications; additionally, the table in each section cross-reference
to the illustrations found in
Appendix A

Appendix A. CABLE DRAWINGS

Chapter 4. CABLES AND CONNECTIONS
.
A-1
CRS-280/280L IF Switch for 1:N Redundancy
MN-CRS-280/280L
Revision -