Removing The Lower Unit; Removing The Water Pump; Removing The Oil Seal Housing And Shift Rod - Yamaha E60HWD Service Manual

LOWR

Removing the lower unit

1. Drain the gear oil.
2. Shift the shift lever or remote control
lever to neutral, place a block of wood
between the anti-cavitation plate and pro-
peller to keep the propeller from turning,
and then remove the propeller nut and
propeller.
w
9 Do not hold the propeller with your
hands when loosening or tightening it.
9 Be sure to disconnect the battery leads
from the battery and the clip from the
engine stop lanyard switch.
9 Put a block of wood between the anti-
cavitation plate and propeller to keep the
propeller from turning.
3. Mark the trim tab at the area shown.
4. Remove the cover 1, then remove the
trim tab bolt 2 and trim tab 3.
6-9
Lower unit
69D60015
5. Loosen the bolt 4 and nuts 5, and then
remove the lower unit from the upper
case.
5
åX-transom model

Removing the water pump

1. Remove the water pump assembly.
Removing the oil seal housing and
shift rod
1. Remove the oil seal housing 1, and then
remove the shift rod assembly 2.
2
1
å
2
3
4
69D60020
1
69D60030
69D5G11