Example Of Configuring Vlan Groups - Cisco Catalyst 2960-X Security Configuration Manual

Configuring 802.1x User Distribution
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2 vlan group vlan-group-name vlan-list vlan-list
Example:
Switch(config)# vlan group eng-dept vlan-list 10
Step 3 end
Example:
Switch(config)# end
Step 4
no vlan group vlan-group-name vlan-list vlan-list
Example:
Switch(config)# no vlan group eng-dept vlan-list
10

Example of Configuring VLAN Groups

This example shows how to configure the VLAN groups, to map the VLANs to the groups, to and verify the
VLAN group configurations and mapping to the specified VLANs:
Switch(config)# vlan group eng-dept vlan-list 10
Switch(config)# show vlan group group-name eng-dept
Group Name
-------------
eng-dept
Switch(config)# show dot1x vlan-group all
Group Name
-------------
eng-dept
hr-dept
This example shows how to add a VLAN to an existing VLAN group and to verify that the VLAN was added:
Switch(config)# vlan group eng-dept vlan-list 30
Switch(config)# show vlan group eng-dept
Group Name
-------------
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
336
Configuring IEEE 802.1x Port-Based Authentication
Purpose
Enters the global configuration mode.
Configures a VLAN group, and maps a single VLAN
or a range of VLANs to it.
Returns to privileged EXEC mode.
Clears the VLAN group configuration or elements of
the VLAN group configuration.
Vlans Mapped
--------------
10
Vlans Mapped
--------------
10
20
Vlans Mapped
--------------
OL-29048-01