Override Function - Rinnai RHFE-308 FTR Installation And User Manual

This function is intended to be used to manually override the current operation of the heater, For
example; if the heater is in standby mode (i.e. between finishing time and starting time of a Timer), and
the Override button is selected, then the heater will begin to operate, and heat the room.
1
To operate the Override simply press the Override
button. The Override indicator will flash.
2
To manually deactivate the Override simply press the
Override button again. The Override indicator will go
out, and the heater will return to standby mode.
The heater will continue to operate on Override until the Override button is pressed again, or one of the
Timers takes over the operation of the appliance. This means that the Override mode will automatically
drop out if a programmed Starting time is reached. The appliance will then return to operating at times
programmed into the Timer(s).
USING THE REMOTE CONTROL
To Turn ON or OFF
Remote Control will not turn heater ON if
Timer(s) have been selected.
To manually operate
when Timer(s) are not
selected, simply press
the ON or OFF button.
If the Timer(s) have been selected, and the heater is in standby mode, and the OFF button on the
Remote Control is pressed, the Timer(s) will be deactivated.

OVERRIDE FUNCTION

ON
OFF
Timer 1 Timer 2 Override
Timer 1 Timer 2 Override
To Change Temperature
To alter the
temperature at any time
while the heater is
operating, simply press
the "L" or "M" buttons.
– 18 –
AM
PM
Set ・ Room
Temp
・
Time
AM
PM
Set ・ Room
Temp
・
Time