Summary of Contents for Rinnai Energysavers RHFE-309FT
Page 1
Approved by the Asthma and Respiratory Foundation NOT INTENDED FOR FIREPLACE INSERT. Appliance must be installed with a Rinnai supplied flue system. For flueing installation details refer to separate instructions. Appliance must be installed, commissioned and serviced by a licensed tradesperson in accordance with these instructions and all applicable local rules and regulations.
Page 2
3 below, Rinnai New Zealand Limited supervising gas fitter’s registration number (“Rinnai”) will, at its own discretion, either and the gas fitting certification number. replace or repair any defective product at 4. This warranty commences from the date of no charge to the customer.
Flueing: Installation configurations Energysaver installation ® Installer details Wiring diagram WARNING Improper installation, adjustment, alteration, service or maintenance can cause property damage, personal injury or loss of life. For assistance or additional information contact Rinnai on 0800 RINNAI (0800 746 624).
About your Energysaver ® At Rinnai, we’re committed to a positive future for New Zealand and our customers. Our high efficiency Energysaver range not only ensures a warm home, but a healthy home. ® Rinnai Energysavers are simple to operate, the layout below highlights where some of the key components are positioned.
In the event of a power failure or power cut, the gas valves will automatically close. After the power is reinstated the appliance will automatically restart. The time of day will need to be reset to the current time. Rinnai New Zealand Energysaver Operation and Installation Manual: ®...
Page 6
About your Energysaver ® Control panel layout (both models) Rinnai New Zealand Energysaver Operation and Installation Manual: ® RHFE-309FT and RHFE-559FT (01-10)
Keep the heater Always turn the away from heater OFF after flammable use. materials. Do not allow curtains or other combustible materials to come into contact with the appliance. Rinnai New Zealand Energysaver Operation and Installation Manual: ® RHFE-309FT and RHFE-559FT (01-10)
Page 8
This heater must not be built-in. The clearances FRONT shown 1000 mm must be maintained 50 mm 50 mm (including LEFT SIDE RIGHT SIDE curtains). Rinnai New Zealand Energysaver Operation and Installation Manual: ® RHFE-309FT and RHFE-559FT (01-10)
Humidifier tray Ensure the access panel and humidifier tray are in place before using your Energysaver ® Rinnai recommend you fill the tray to the water level indicator as marked—taking care not to overfill. Rinnai New Zealand Energysaver Operation and Installation Manual: ®...
Rinnai has a maintenance, service and spare parts network with personnel who are fully trained and equipped to give the best advice on your Rinnai appliance. If your appliance needs maintenance or servicing for repair, please call Rinnai (0800 746 624) from a land line and select option one for a service centre in your area.
15 seconds. After this, it will be necessary to press the ON/OFF button OFF then ON again. If the appliance fails to ignite after four attempts, contact Rinnai as a service call may be required.
Page 12
Fan operation The fan turns on automatically when the heater warms up and when it cools down. This helps prevent cold draughts and maximises efficiency. Rinnai New Zealand Energysaver Operation and Installation Manual: ® RHFE-309FT and RHFE-559FT (01-10)
Don’t worry if you make a mistake during programming. By pressing the Set Times button you can cycle through the different programming options (clocks and timers) and change if required. Rinnai New Zealand Energysaver Operation and Installation Manual: ®...
Timer programs but the clock will stop at the time the power goes off. The clock will restart when the power comes back on, but the time will be slow by the duration of the power failure. Rinnai New Zealand Energysaver Operation and Installation Manual: ®...
These louvres are not designed to be adjusted more than six times as the louvres will weaken and break. Rinnai New Zealand Energysaver Operation and Installation Manual: ®...
Ensure the fan filter is fitted back into the appliance after cleaning. DO NOT operate the appliance without the filter in place. WARNING Rinnai New Zealand Energysaver Operation and Installation Manual: ® RHFE-309FT and RHFE-559FT (01-10)
In all cases, you may be able to clear the error message by turning the heater off then on again. If the error message remains or returns when the heater is used again, contact Rinnai or a Rinnai Service Centre.
Check the following information before making a service call as some performance characteristics are a normal part of operation. If you are still unsure or concerned after reading this section, please contact Rinnai. Using the heater for the first time or after long periods of non-use Ignition may not occur the first time it is operated due to air in the gas pipes.
Page 19
Cancel ON Timer or press the Override button Gas turned off at Turn gas on at meter meter Child Lock set Deactivate Child Lock Rinnai New Zealand Energysaver Operation and Installation Manual: ® RHFE-309FT and RHFE-559FT (01-10)
Check all components have been supplied and that you have the correct gas type. The carton should contain: 1 x Rinnai space heater (RHFE-309FT or RHFE-559FT) 1 x Rear cover set, comprising of left, right and top cover panels 1 x Bolt pack containing: •...
230 V 50 Hz with supply cord and 3-pin plug Centrifugal drum type fan Cross flow fan Gas Connection R½ male (15 mm) Gas Control Rinnai electronic modulating gas control valve Gas Type NG and ULPG Humidifier Tray Capacity 0.7 L 1.0 L Ignition Direct continuous spark electronic ignition—no pilot...
(cord supplied is 1500 mm). It must not be above the unit as this is a potential fire hazard. If the supply cord is damaged and requires replacing, it must be replaced by a licensed tradesperson. This must be a genuine replacement part available from Rinnai. RHFE-309FT RHFE-559FT...
Flueing: General For all installations a Rinnai Energysaver flue system MUST BE used. The flue system ® must be fully assembled and secured in place before the heater is installed. IMPORTANT For detailed flueing instructions refer to the Energysaver Flue Installation Manual supplied ®...
Page 25
For horizontal and down and out installations there must be a continuous fall of at least 2 °. This equates to approximately 20 mm per metre to the termination point to drain condensate. For standard direct flueing the Rinnai flue kits have an inbuilt 2 ° fall.
Securing brackets Heater centre Line Floor Level Attach the two securing brackets supplied to the wall using the two 8 g x 30 mm screws (or suitable equivalent). Rinnai New Zealand Energysaver Operation and Installation Manual: ® RHFE-309FT and RHFE-559FT (01-10)
Page 29
Ensure you leave the completed checklist with the customer. Explain to the customer about the use and care of the unit and that they understand the instructions and operation of the Rinnai Energysaver ®...
Installer name:_______________________________________________________________ Address:____________________________________________________________________ ___________________________________________________________________________ Phone:_______________________________ Mobile:______________________________ Certificate of Compliance number for installation:____________________________________ Signed:______________________________ Date:_______________________________ Installer, please remember to complete and leave the Commissioning Checklist with the customer. Rinnai New Zealand Energysaver Operation and Installation Manual: ® RHFE-309FT and RHFE-559FT (01-10)
Flame Rod grey Convection Fan Motor orange Sparker brown OH. TH Overheat Thermistor SV1~2 Solenoid Valve 1~2 Combustion Fan Motor OHS. 1~2 Overheat Switch 1~2 Terminal Block Rinnai New Zealand Energysaver Operation and Installation Manual: ® RHFE-309FT and RHFE-559FT (01-10)
Page 32
(09) 257 3899 Email: info@rinnai.co.nz Websites: www.rinnai.co.nz and www.rinnai-tradesmart.co.nz All Rinnai appliances meet or exceed the safety standards required by New Zealand gas and electrical regulations. Rinnai is constantly improving its products and as such information and specifications are subject to change or variation without notice.