Rinnai RHFE-308 FTR Installation And User Manual page 15

PROGRAMMING THE ON/OFF TIMER(S)
Before programming the Timers you must ensure that the clock has been set to the correct time.
See page 14.
As an example let's programme Timer 1 to heat the room by 7:10 AM and finish at 9:00 AM.
1
Press the Set Times button twice. The Digital Display
will show AM 6:00. Timer 1 indicator will flash.
2
Press the " " button until AM 7:00 appears, release
the button, then press it again until AM 7:10 appears.
(Press the " " button if you go past AM 7:10.)
3
Press the Set Times button again, the Timer 1 OFF
indicator will flash. Press the "
9:00 appears.
4
Press the Set Times button three times to lock in the
programmed time. The Digital Display will show the
current time. A small indicator on the Digital Display
will flash to show that the Display has returned to the
clock.
TURN TO NEXT PAGE TO OPERATE THE TIMERS.
TIMER 2 is programmed in the same way, remember to ensure that the Timer 2 indicator is flashing
when you programme in the desired setting.
The Timers can be programmed to operate for any two periods in any 24 hours. Turn to next page to
operate the dual timer.
The programmed time must be selected and locked-in within one minute of the On Timer indicators
flashing otherwise the programmed times will not be retained in the system memory.
AM
PM
" button until AM
– 15 –
Clock
AM
Timer 1
PM
Timer 2
Set ・ Room
Temp
・
Time
Clock
Timer 1
on off
Timer 2
Set ・ Room
Temp
・ Set times
AM
Time
PM
2 Override
Clock
AM
Timer 1
PM
Timer 2
Set ・ Room
Temp
・
Time
Clock
AM
Timer 1
PM
Timer 2
Set ・ Room
Temp
・ Set times
Time
on off
Set times
Clock
Timer 1
on off
Timer 2
Set ・ Room
Temp
・
Set times
Time
on off
Set times
on off