Assembling Table Extensions - RIDGID TS3650 Operator's Manual

.SP6498 Belt Drive Saw 05/03

Assembling Table Extensions

1. From the blister pack locate the
following hardware:
indicated is for two extensions)
8 Hex Head Screws,
5/16-18 x 3/4" Long
with washers
NOTE: Assemble with saw upside
down.
WARNING: Stock table exten-
sions must be installed. They
help support the fence guide
bars. An unsupported guide bar
can twist. Twisted guide bars
can misalign fence. A misaligned
fence can cause binding or kick-
back. You could be hit or cut.
2. Insert four (4) 5/16-18 x 3/4 in. long
screws with washers through the
holes in each extension and screw
into the table. Do not tighten.
3. Repeat step 2 to install the other
extension.
4. Stand saw upright on legs. Roll saw
over onto front then up onto feet.
WARNING: The saw is heavy. To
reduce the risk of back injury, get
help to lift the saw. Hold the saw
close to your body. Bend your
knees so you can lift with your
legs, not your back.
5. Line up the front edge of extension
with the front edge of the table. At
the spots marked "X" in the
drawing, tighten a "C" Clamp over
the edge of table and extension.
Use a combination square to check
the alignment of the front and top
edges nearest the "X"'s. Tighten
the two corner nuts only with a 1/2"
wrench.
NOTE: This assembly may also be
done without the use of a "C" Clamp.
7/15/03 7:04 AM Page 21
(Quantity
5/16-18 x 3/4 In.
Hex Head Screw
21
With Washers
Hex
Screw
With
Washers
"C" Clamps
Align Front Edges