To Install And Level Table Extensions; Support Rail; Threaded Stud - RIDGID R4511 Operator's Manual

ASSEMBLY
TO INSTALL AND LEVEL TABLE EXTENSIONS
See Figures 27
-
28.
• Screw threaded studs into holes on the side of the table
top.
• Using a 4 mm hex key, screw the studs into the table top
leaving approximately 1 -3/8 in. of threads showing.
• Slide support rails into slots under the table top.
NOTE:
When correctly installed, the set screws on the
support rail will be under the table extension not the table
top.
With the aid of another person, slide the table extension
(beveled edge to the front) onto the support rails and up
against the table top.
• Secure table extensions using flat washers, lock washers,
and hex nuts. Finger tighten.
Using a framing square, check the alignment of the
table top edge to the extension rail edge. To level the
table extension and top, turn the table leveling screws
clockwise or counterclockwise to raise or lower the
extensions as needed.
• Once level, securely tighten the hex nuts on the threaded
stud.
• Repeat above steps for the other extension table.
TABLE LEVELING
SCREWS
Fig. 28
Fig. 29
23