Lower Assembly - RIDGID TS3650 Operator's Manual

.SP6498 Belt Drive Saw 05/03
Assembly (continued)

Lower Assembly

1. Locate the following hardware.
4 Hex Head Screw w/Washer
1/4-20 x 2
4 Lock Nut 1/4-20
4 Hex Nut w/Serrated Flange
5/16-18
2 Hex Nut w/Serrated Flange 7/16
1 U-Bolt
2. From the loose parts find the
following:
2 Caster
2 Tube Front (13-7/8" Long)
1 Tube Support (17-1/4" Long)
1 Tube U-Bolt (19-5/8" Long)
3. Assemble support tube (17-3/4 inch
length) to both front tubes (13-7/8
inch length) using two each 1/4-20 x 2
hex head screw, and lock nut as
shown. Loosely assemble at this
time.
NOTE: The larger hole at the end of the
front tube must face down as shown.
4. Align and assemble U-bolt tube
(19-5/8 inch length) with holes in the
front tube using two each 1/4-20 x 2
hex head screw, and lock nut as
shown. Loosely assemble at this time.
5. Assemble 5/16 nut on each side of
U-bolt as shown with serration facing
tubing.
6. Place U-bolt through holes in U-bolt
tube. Assemble 5/16 nuts on each
side of U-bolt as shown with serration
facing tube.
7. Adjust U-bolt about two inches from
tube.
8. Assemble caster through tube. Fasten
with 7/16 nut as shown. Tighten nuts
securely. Use adjustable wrench on
caster stem hex to keep stem from
turning while tightening nut.
7/15/03 7:04 AM Page 28
Assemble each tube exactly as
shown. Note both front tubes are
placed on top of the tube U-bolt
and tube support as shown.
28