Assembly; Attaching Leveling Feet; Assembling Leg Set - RIDGID BS1400 Owner's Manual

Assembly

Attaching Leveling Feet

1. From the loose parts bag find the fol-
lowing items:
4 Leveling feet
8 Hex nut 3/8-16
2. From the loose parts find the following
items:
4 Leg
3. Put a hex nut on each of the leveling
feet and screw it down towards the rub-
ber foot.
4. Put the leveling feet through the holes
in the bottom of each leg.
5. Put another hex nut on each of the lev-
eling feet and hand tighten until they
are next to the bottom support of the
leg.
WARNING: After the band saw
has been attached to the legset,
it will be necessary to adjust the
leveling feet so the saw does not
rock.

Assembling Leg Set

1. From the loose parts bag find the fol-
lowing hardware:
40 Carriage Bolts M8 x 1.25-16
40 M8 Washers
40 M8 Lockwashers
40 M8 Nuts
2. From the loose parts find the following
items:
4 Legs (With Attached Leveling Feet)
2 Stiffeners (short)
2 Stiffeners (long)
1 Stand top
Leveling
Foot
Bolt Carriage
M8 x 1.25-16
Washer M8
Legs
Stand Top
15
Hex Nut 3/8-16
Leg
Leg
Hex Nut 3/8-16
Leveling Foot
Lockwasher
Nut Hex M8
M8
Stiffener (Long)
Stiffener (Short)