Attaching Wood Face Board - RIDGID TS3650 Operator's Manual

.SP6498 Belt Drive Saw 05/03

Attaching Wood Face Board

1. A T-slot is provided in the rip fence for
attaching a wood facing when using
the dado head, or molding head,
featherboards or other jigs and
fixtures.
2. Select a piece of smooth straight
wood approximately 3/4 inch thick,
and the same length as the rip fence.
7/15/03 7:05 AM Page 53
3. To fasten wood face to the fence use
the three 1/4"20 x 3/4" square head
bolts, lock-washers, flat washers and
nuts supplied. Counterbore three 3/4"
dia. holes 3/8" deep into the 3/4"
board at the dimen-sion shown. Avoid
placing screws directly over blade.
4. Drill a 9/32" clearance hole through
the board at each counterbore
location.
53