Table of Contents
Advertisement
.SP6498 Belt Drive Saw 05/03
Basic Saw Operations (continued)
Using the Rip Fence
Ripping, bevel ripping, resawing and
rabbeting are performed using the rip
fence together with the auxiliary
fence/work support, push stick or
push block.
Additional Safety Instructions for Rip Cuts
• Never use the miter gauge when
ripping
• Use a push stick whenever the
fence is 2 inches or more from the
blade.
• When thru-sawing, use an auxiliary
fence and push block whenever the
fence must be between 1/2 and 2
inches from the blade.
• Never thru-saw rip cuts narrower
than 1/2 inch.
• Never rip anything shorter than 10"
long.
• When using a push stick or push
block, the trailing end of the work-
piece must be square. A push stick
or block against an uneven end
could slip off or push the workpiece
away from the fence.
• A featherboard can help guide the
workpiece.
(See
Operation - Using Featherboards
for Thru-Sawing" section.)
• Always use featherboards for any
non thru-sawing rip type cuts. (See
"Basic Saw Operations - Using
Featherboards
for
Sawing" section.)
7/15/03
7:05 AM
Page 60
WARNING: For your own safety,
read and always observe all
safety precautions listed in
manual and on saw.
Before Starting:
• To reduce the risk of kickbacks and
slips into the blade, make sure the
rip
fence
sawblade.
• Before thru-sawing, check the anti-
kickback pawls. the pawls must
stop a kickback once it has started.
Replace or sharpen anti-kickback
pawls when points become dull.
Plastic and composition (like hard
board) materials may be cut on your
saw. However, since these are usually
quite hard and slippery, the anti-
kickback pawls may not stop a kick-
back. Therefore, be especially careful
in your setup and cutting procedures.
While Thru-sawing:
To reduce the risk of kickbacks and
slips into the blade, always push
forward on the section of the work-
"Basic
Saw
piece between the sawblade and the
rip fence. Never push forward on the
piece being cut off.
Non
Thru-
60
is
parallel
to
the
Hide quick links:
Advertisement
Table of Contents
