Mounting The Motor - RIDGID TS3650 Operator's Manual

.SP6498 Belt Drive Saw 05/03
Assembly (continued)
4. Place rip fence on the right hand
side of table. Carefully move it
against blade so that it is parallel to
the blade, and just touches tips of
saw teeth. Tighten rip fence lock
lever.
5. Insert folded paper
spreader and fence.
6. Using M10 wrench loosen the
1/4-20 hex head screws so the
spreader can slide sideways.
7. Hold spreader flat against folded
paper and fence. Tighten screws
using M10 inch wrench.
8. To remove blade guard and
spreader, loosen
Do not loosen other screws. This
allows you to remove and replace
the guard for non-through cuts
without disturbing the spreader
alignment.

Mounting the Motor

1. Remove Motor Assembly.
2. Loosen the two hex head screws
that lock the pins in the cradle.
3. Lift motor and insert the two pins on
motor support assembly into holes
in cradle. Push motor in as far as it
will go. Do not tighten screws at this
time.
7/15/03 7:04 AM Page 38
M10
Wrench
between
thumbscrew.
Cradle
38
Folded Paper
Hex Head Screws
Motor
Hex Head Screws (2)
Pin (2)
Motor
Support
Assembly