Assembly; Assembling And Aligning The Table Extension; Attaching Dust Elbow And Dust Bag - RIDGID MS1250 Owner's Manual

Assembly

WARNING: For your own safety, never connect
plug to power source outlet until all assembly
steps are complete, and you have read and under-
stood the safety and operational instructions.
Assembling and Aligning the Table Exten-
sion
1. Locate the table extension. Locate the bag assembly
with the two cap screws and two washers.
2. Place the two bolts and washers through the holes in
the table extension and fasten onto the end of the
table. Finger tighten only.
3. Use a straight edge to align the table extension to both
the fence and base of the saw as shown.
4. Using the 1/4" hex end of combination wrench securely
tighten the two cap screws.

Attaching Dust Elbow and Dust Bag

Place the dust elbow into the 2-1/2 inch dust port at the
rear of the saw.
To attach the dust bag squeeze the spring clamp on the
bag and place it over the dust elbow.
If desired a 2-1/2 inch wet/dry vac hose may be inserted
into the dust port or into the elbow.
If desired, the dust bag may be attached directly to dust
port on saw.
WARNING: To reduce the risk of injury from thrown
sawdust and wood chips, never operate saw with-
out dust bag, dust elbow, or vac hose installed.
Always direct elbow away from bystanders and
operator.
Lock Pin
Cap Screws
10
Table Extension
Washer
Straightedge