Table of Contents
Advertisement
Messages
Remove Paper Standard
Tray
Replace Maintenance Kit
Replace PCU
Reset Duplex Unit Correct-
ly
Reset Fusing Unit Correct-
ly
Reset PCU Correctly
Reset Tray 1 Correctly
Resetting Job...
Warming Up...
Error & Status Messages on the Operation Panel
Description
The standard output tray is
full.
It is time to replace the
parts included in Mainte-
nance Kit.
It is time to change Photo
Conductor Unit.
AD370 (duplex unit) is not
set correctly.
There is no fusing unit, or
the fusing unit is not in-
stalled properly.
Photo Conductor Unit is
not installed in the printer.
There is no paper tray, or
Tray 1 is not set correctly.
Note
This message appears
only for the default tray.
P.94 "Job Control Pa-
rameters"
The job is being reset.
The printer is now prepar-
ing for printing.
Resolution
Remove paper from the
standard output tray.
Important
Remove paper from the
output tray before it be-
comes full. If you leave
paper in the output tray,
it can cause a paper mis-
feed.
Replace the parts included
in Maintenance Kit.
After replacing the kit,
clean the registration roll-
ers.
Replace Photo Conductor
Unit.
Set AD370 (duplex unit)
correctly.
Install the fusing unit prop-
erly. For more information
on the fusing unit, see
"Maintenance Kit Type 270
Replacement Guide" that
comes with the mainte-
nance kit.
Set Photo Conductor Unit
correctly.
Set the tray correctly.
Wait for a while.
Wait until the printer is
warmed up.
5
61
Advertisement
Table of Contents
