Table of Contents
Advertisement
Troubleshooting
Messages
Reset Duplex
Unit Correctly
Reset Fusing
Unit Correctly
Resetting Job...
Reset PCU
Correctly
5
Reset Tray 1
Correctly
Setting Changed
Cannot Print
Waiting...
Warming Up...
Note
If you cannot solve the problem by taking the actions listed in the preceding
table, turn the power off, and then back on again. If this does not clear the er-
ror message, take a note of the contents and number of the error message and
contact your sales or service representative.
56
Description
AD370 (duplex unit) is not
set correctly.
There is no fusing unit, or
the fusing unit is not in-
stalled properly.
Resetting Print job.
There is no Photo Conduc-
tor Unit, or Photo Conduc-
tor Unit is not installed
properly.
There is no paper tray, or
Tray 1 is not set correctly.
Note
This message appears
only for the default tray.
P.94 "Job Control Pa-
rameters"
The paper feed unit setting
has been changed, and the
proof print failed.
Printer is waiting for the
next data to print.
The printer is now prepar-
ing for printing.
Comments
Set the AD370 (duplex unit)
correctly.
Install the fusing unit prop-
erly. For more information
on the fusing unit, see the
"Maintenance Kit Type 270
Replacement Guide" that
comes with the mainte-
nance kit.
Wait for while.
Install Photo Conductor
Unit again. For more infor-
mation on Photo Conduc-
tor Unit, see the "Photo
Conductor Unit Replace-
ment Guide" that comes
with the photo conductor
unit.
Set the tray correctly.
Configure the paper feed
unit correctly, and try
again.
Wait for a while.
Wait until the printer is
warmed up.
Advertisement
Table of Contents
