Installing Memory - Intel SE7501CW2 Installation & Integration

Installing Memory

The server board supports only DDR266-
compliant DIMMs. The minimum supported
memory configuration is 128 MB, using one
128-MB DIMM. The maximum configurable
memory size is 8 GB using 4 2-GB DIMMs.
If a single DIMM is used, you must install it
in the DIMM 1A socket. Bank 1 must be f
populated before you install any memo
Bank 2, and Bank 2 only operates wit
DIMMs installed. DIMMs must be identical
within each bank.
Note:
Use memory that has been tested for compatibility with the server
board. For a list of tested memory, see:
http://support.intel.com/support/motherboards/server/SE7501CW2/tested_mem.htm
If the server board is not already installed in the c
remove the server board from its packaging and place it
on a clean ESD-protected work surface.
1. Open both DIMM socket levers.
2. Insert DIMM, making sure the connector edge of the
DIMM aligns correctly with the slot.
3. Check that the socket levers are securely latched.
DIMMs must be populated in identical pairs.
Intel Server Board SE7501CW2 Installation and Integration Guide
ully
ry in
h two
hassis,
11