Cable Routing - Intel Server Chassis Sc5200; Ide Or Scsi Cables; Floppy And Front Panel Cables; Installing The Access Cover - Intel SE7501CW2 Installation & Integration

Cable Routing – Intel Server Chassis SC5200
To ensure proper airflow within the chassis, follow the cable

IDE or SCSI Cables

Cables that connect to devices in the lower
device bays should be routed around the EPAC
sys tem fan carrier as shown.
1. Route ca bles as shown.
2. Replace the top half of the EPAC.

Floppy and Front Panel Cables

Route the floppy drive and front panel cables as
shown.

Installing the Access Cover

1. Place the cover so the tabs go into the slots on the
server. The cover should be flush against the chassis.
2. Slide the cover forward until it stops.
3. Tighten the two captive screws into the rear of the
chassis.
Intel Server Board SE7501CW2 Installation and Integration Guide
routing guidelines below.
19