ResMed Flow Generator S8 Elite System Illustration Manual page 28

•
•
2 C
OPY
•
•
•
•
3 R
EMOVE THE
Grip the end of the Data Card and pull it out of the Data Card module (H-3).
4 S
TORE THE
Your Data Card should be stored in its mailback envelope when not in use.
5 M
AILING THE
A bubble mailer envelope is provided to ensure safe transportation of the Data Card.
When mailing the Data Card to your clinician:
1. Insert the Data Card into the pocket provided on the mailback envelope. Fold up
the mailback envelope.
2. Place the mailback envelope containing the Data Card in the bubble mailer
envelope and seal it.
3. Make sure that your clinician's name and address details are on the bubble mailer
envelope, and mail it back immediately.
U
SING THE
If your clinician has provided a Data Card with new device settings:
With the device in standby (Ramp) mode, insert the Data Card into the slot on
•
the Data Card module. Updating will start automatically.
The "Card Inserted Please Wait" message is displayed on the LCD while updating
•
is in progress. Updating takes up to 30 seconds.
The "Settings Success Remove Card" message is displayed on the LCD if the
•
settings were updated successfully.
Note: This message only appears once. If you re-insert the Data Card after you have
updated your settings, this message is not displayed.
Remove the Data Card from the Data Card module.
•
Store the Data Card in its mailback envelope when not in use.
•
WARNING
!
If your clinician has told you to use this Data Card to update the settings on your
device and the "Settings Success" message does not appear, contact your clinician
immediately.
24
Hold the Data Card with the arrow facing up, and insert it into the slot in the
Data Card module (H-1).
Push the card in smoothly until it stops moving (H-2) and messages start
appearing on the LCD.
D
ATA ONTO THE
Data copying starts automatically when the Data Card is inserted into the Data
Card module.
The "Card Inserted Please Wait" message is displayed on the
while data is being copied. Copying takes up to 30 seconds.
The "Copy Complete Remove Card" message is displayed on the LCD when
copying has finished.
Remove the Data Card from the Data Card module.
D C
ATA ARD
D C
ATA ARD
D C
ATA ARD TO YOUR
D C
ATA ARD TO
D C
ATA ARD
C
LINICIAN
U S
PDATE ETTINGS
LCD
S8 E
LITE