Working On 4-Stroke Injection Systems; To Remove The Fuel Pump - PEUGEOT Elystar Workshop Manual

WORKING ON 4-STROKE INJECTION
SYSTEMS

To remove the fuel pump

Note: Before carrying out any work, leave the
engine to cool for a minimum of 2 hours.
Petrol is highly inflammable, do not smoke in the
working area and avoid proximity to flames or
sparks.
Work in a well ventilated area
- Remove the ignition key
- Remove the lower panel (2) fixing screws (1)
- Remove the rear panel (4) fixing screws (3)
- Remove the rear panel by pulling it rearwards
- Remove the side panel assembly (7) 6 screws (5)
and the 2 plasti-rivets (6)
- Release the saddle opening catch
- Remove the side panel assembly
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles

WORKING ON 4-STROKE INJECTION SYSTEMS

Page : 17