PEUGEOT Elystar Workshop Manual page 40

Important: It is essential to avoid being under the
master cylinder during bleeding to avoid brake
fluid splashes
- Operate the brake lever evenly and smoothly whilst topping up the fluid in the master cylinder
- Stop when there are no more bubbles coming from the control unit bleed screw
- Close the bleed screw
- Disconnect the pipe connecting it to the recipient
- Using the diagnostic tool operate the pump to assess lever firmness
Note: If the lever does not feel sufficiently hard, bleed the power braking circuit.
- Operate the brake lever again slowly to check there are no more bubbles in the circuit
- Check the brake fluid level in the master cylinder, top up if necessary and fit the cover
Important: The brake fluid level in the master cylinders in the horizontal position must always be above the
sight gauge level.
- Re-fit the bleed screw cap
Note: If the lever does not feel sufficiently firm, repeat the control unit bleed operation.
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
WORKING ON THE ABS/PBS SYSTEM
Page : 40