PEUGEOT Elystar Workshop Manual page 44

- Ensure that the fluid level in the master cylinder does not drop below the pipe connecting with the control
unit reservoir
- Stop the operation when there are no more bubbles in the transparent pipe
- Close the bleed screw
- Turn off the ignition
- Disconnect the transparent pipe by clamping the other end to stop the fluid running out
- Check the brake fluid level in the master cylinder and top up if necessary.
Important: The brake fluid level in the master cylinders in the horizontal position must always be above the
sight gauge level.
- Check the brake fluid level in the control unit reservoir and top up if necessary.
- Refit the master cylinder cover
- Check the levers are firm
- Using the diagnostic tool, operate the control unit pump and exert a high pressure on each of the levers to
ensure they are operating correctly
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
WORKING ON THE ABS/PBS SYSTEM
Page : 44