PEUGEOT Elystar Workshop Manual page 36

- Operate the right brake lever evenly and smoothly whilst topping up the fluid in the master cylinder
- Stop when there are no more bubbles coming from the control unit
- Close the bleed screw
- Re-fit the bleed screw cap
4) Remove the front caliper bleed screw cap
- Connect the bleed screw to a recipient containing
brake fluid using a transparent pipe. The recipient
must be kept higher than the brake caliper to
facilitate checking that the air bubbles are being
expelled.
- Open the caliper bleed screw half a turn
- Operate the brake lever evenly and smoothly whilst topping up the fluid in the master cylinder
- Stop when there are no more bubbles coming from the caliper
- Close the bleed screw
- Disconnect the pipe connecting it to the master cylinder
- Operate the pump using the diagnostic tool
- Check the lever is firm
Note: If the lever does not feel sufficiently firm, repeat the operation as from paragraph 2.
- Re-fit the bleed screw cap
- Check the brake fluid level in the master cylinder, top up if necessary and fit the cover
Important: The brake fluid level in the master cylinders in the horizontal position must always be above the
sight gauge level.
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
WORKING ON THE ABS/PBS SYSTEM
Page : 36