Disassembly and Reassembly
4-38 Sensor board
1. Before you remove the sensor board, you should
remove:
– Rear cover (see page 4-9)
– Shield Engine ass'y (see page 4-19)
2. Release four snap-fits securing the sensor board
and unplug one connector from the main board,
then remove the sensor board.
4-39 Actuator Empty/Feeder
1. Before you remove the actuator empty/feeder,
you should remove:
– Rear cover (see page 4-9)
– Shield Engine ass'y (see page 4-19)
2. Remove one connector from the main board and
two screws securing the holder feed ass'y, then
remove the holder feeder ass'y.
4-22
3. Remove the Feed sensor and the Empty sensor.
Feed Sensor
Empty Sensor
Samsung Electronics