Prestart Checklist; Raising The Mast-Manual Winch - Generac Power Systems MLT6SMD Owner's Manual

Operation

Prestart Checklist

All items in the prestart checklist must be completed prior
to starting the unit. This checklist applies to both manual
and remote starting of the unit.
WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.

Verify all maintenance procedures are up to date. For
more information, refer to
Basic Maintenance

The unit must be level.

The unit must be dry. Inspect for water inside or near
the unit; dry if needed.

For grounding requirements, follow any local, state,
or National Electrical Code (NEC) guidelines.

Verify the control power switch is OFF (O).

Verify all circuit breakers are OFF (O).

Inspect all electrical cords; repair or replace any that
are cut, worn, or bare.

Verify all winch cables are in good condition and
centered on each pulley. Do not use if cables are
kinked or beginning to unravel.

Check oil, coolant, and fuel levels. For more
information, refer to General

Verify battery connections are secure.

Turn the battery disconnect switch on, if equipped.

Inspect the engine fan belt tension and condition.

Inspect the engine fan belt guard.

Inspect the engine exhaust system for loose or
rusted components.

Verify all covers are in place and secure.
30
(000100a)
General Maintenance
Schedule.
Maintenance.
Raising the Mast—Manual Winch
Electrocution. DO NOT use the unit if
electrical cord is cut or worn through. Doing
so will result in death or serious injury.
Tipping hazard. Extend the outriggers and level the unit
before raising the mast. Keep the outriggers extended while
the mast is up. Failure to do so could cause the unit to tip
and
and fall and could result in death or serious injury.
1. Set up and level the unit. See
2. See Figure
sive wear or damage. Verify the cables are prop-
erly centered in each pulley (A). Inspect the
electrical cord for damage.
A
C
B
Figure 3-2. Pulley Locations - Manual Winch
Owner's Manual for MLT6SMD Light Tower
DANGER
WARNING
Light Tower
3-2. Inspect the mast cables for exces-
DETAIL D
D
(000263a)
(000266)
Setup.
STOP
006438