How To Replace The Separating Knife - Roland CX-500 User Manual

8-3 How to Replace the Separating Knife

Make sure the power to the unit is
off before attempting to replace the
separating knife.
Doing so may result in injury.
If the separating knife, replace it with the replacement knife included with the CX-500/400/300. Follow the steps below to replace
the knife.
1
Switch off the power to the CX-500/400/300.
2
Remove the separating knife.
(1) Loosen the screw until it slips out.
(2) Grasp the screw portion, and slowly pull it out in
the direction of the arrow.
* Do not pull back while doing this.
3
Replace with a new knife.
4
Install the separating knife.
(1) Grasp the screw portion and slowly insert it into
the groove.
* Take care to ensure that the knife does not slip
(2) Tighten the screw.
52
(1)
* If the blade remains in the carriage, use tweezers to remove it.
Positioning groove
The knife is secured in place
by the magnet.
(2)
(1)
(2)