Roland CX-500 User Manual page 48

Menu
CONTRAST This changes the contrast of the display.
TEST
PATTERN
DEMO CUT This performs an operation check when the CX-500/
AUTOCUT AUTOCUT
MENU COMMAND enabled or disabled.
AUTOCUT
SPEED
MARGIN
AUTOCUT
PASSES
COMMAND COMMAND This selection enables the type of instructions that are
MENU MODE
VS
COMMAND command (tool speed setting command) sent from the
!FS
COMMAND FS command (tool force setting command) sent from
48
Function
This changes the cutting-test pattern carried out when
you press the [TEST CUT] key.
This performs an ordinary cutting test with [TYPE 1].
For thin materials or cases where graphics are too
small to obtain good cutting results with [TYPE 1],
make the setting for [TYPE 2].
TYPE 1
400/300 is not working correctly.
This selects whether the material-cutoff command is
When set to [ENABLE], material cutoff is performed
automatically when a material-cutoff command is sent
from the computer.
Pressing the [SHEET CUT] key performs material
cutoff regardless of whether the setting is [ENABLE] or
[DISABLE].
This sets the [AUTOCUT] (material cutoff) speed.
Set this to a suitable speed for the loaded material.
This sets the amount of margin from the cut edge of the
material for the next starting point for cutting after
cutting off the material.
This sets the number of times material cutoff is
performed (once for [1] or twice for [2]). When working
with thicker material or other material that's difficult to
cut, set this to [2]. Pressing the [SHEET CUT] key once
performs material cutoff the number of times set here.
understood by the unit. You can set the unit to accept
either CAMM-GL III mode 1 instructions or mode 2
instructions.
When set to [AUTO], the CX-500/400/300 automatically
detects the type of instructions first received after
turning on the power, and sets itself to accept those
instructions.
To change the type of instructions, first change the
setting, then switch the power to the unit off and back
on again.
To perform cutting at the speed determined by a VS
computer, set this to [ENABLE]. When set to
[DISABLE], cutting is performed using the values for
[SPEED] and [UPSPEED].
To perform cutting at the blade force determined by an
the computer, set this to [ENABLE]. When set to
[DISABLE], cutting is performed using the values for
[FORCE].
TYPE 2
DISABLE/ENABLE
DISABLE/ENABLE
DISABLE/ENABLE
Range Default
5 to 1 5
TYPE1/TYPE2 TYPE1
– –
DISABLE
40 to 85 cm/s 50 cm/s
(1cm/s step)
5 to 50 mm 30 mm
(5mm step)
1/2 1
AUTO/ AUTO
MODE1/
MODE2
DISABLE
DISABLE