Roland CX-500 User Manual page 26

The Location of the Origin Point Immediately After Loading Ma-
terial (When [AXIS ROTATE] is set to [0deg])
"ROLL" (When using roll material)
(0.0)
"PIECE" (When using flat material)
(0.0)
"F-EDGE" (When performing cutting from as close as possible to the front edge of the
material)
(0.0)
"R-EDGE" (When using the front-loading feature)
(0.0)
* For detailed information about the cutting area, see the following page.
26
Material
Pinch Roller
Depends on length
Margin
when loaded
30 mm
(1-3/16 in.)
Material
Pinch Roller
25 mm
Margin
(1 in.)
Material
Pinch Roller
25 mm
Margin
(1 in.)
30 mm
(1-3/16 in.)
Material
Pinch Roller
The origin point is set at the location where the material is
loaded, near the left pinch roller.
After length in the direction of material feed is detected,
movement 25 mm back from the front edge of the material
is performed, and the origin point is set near the left pinch
roller.
* When the length of the material is 1,600 mm (63 in.) or
longer, the material is determined to be roll material.
The origin point is set in the same way as for "ROLL"
above.
Set the origin point at a location having a margin of 25 mm
from the front edge of the material.
Set the origin point at a location having a margin of 30 mm
from the trailing edge of the material.
When in this state, the cutting area is zero.