Roland CX-500 User Manual page 13

5
Load the material so that it lies straight and is aligned with the guideline marks, then move the left and right pinch rollers so
that they are above the grit rollers.
Position the middle pinch roller over the grit roller that lies between the left- and right-hand pinch rollers.
If the pinch rollers do not move smoothly, try moving them by grasping near the base of the sheet loading lever at the back of
the unit. Load the material so that it is straight. If the material is crooked, straight material feed cannot be performed.
* The CX-300 does not have a middle pinch roller.
Rear View
Sheet loading lever
Material
6
Lift the sheet loading lever.
The pinch rollers are lowered and the material is
secured in place.
When using a material which is narrower than 762 mm
(30 in.), do not lower the middle pinch roller.
7
Position the stoppers so that they lightly touch the
edges of the roll and secure in place by tightening the
screws so that the rolled material does not move from
side to side during material feed.
Position the pinch rollers over
the material, near the edges.
Pinch roller (right)
Material
Guide-line marks
Roll material
Screws
Brake
13