Roland CX-500 User Manual page 55

A message appears on the display
Change Pinch
Roller Position
SHEET UNLOADED
LOAD AGAIN
Motor Err 00800080
Power ON Again
TOOL-CHG:TOOL No.
2
The location of one or more of the pinch rollers is not correct.
If this happens, lower the sheet loading levers and move the pinch rollers to the
proper positions above the grit rollers. Reposition the material to match this new
alignment, then lift the sheet loading levers to hold the material in place. (See "4-
1 Loading the Material (Roll Material)")
This is displayed when the material has been loaded at a position where the
sheet sensor does not function.
Follow the steps under "4-1 Loading the Material (Roll Material)" to load the
material so that it is positioned above the sheet sensor.
This is displayed when the material is removed after pressing the [ENTER]
key.
Load a material and press any key to cancel the error message.
Shows motor error status.
This is displayed when the CX-500/400/300 is heavily loaded, such as during a
media jam, when heavy stock is cut across a long distance without initial material
feed, or when the material is abruptly pulled from the roll during cutting.
In this case, turn the power off and back on again (if a media jam has occurred,
clear the jam before turning the power back on).
For large cutting data with a roll material, use the [AREA MOVE] function on the
display menu to feed the roll material by the length of the cut (ensure a small
margin by setting a length that is about 0.1 m longer than the cutting data).
When you are using thick material, change the [QUALITY] setting from [NOR-
MAL] to [HEAVY]. (See "7-3 List of Functions" and refer to [QUALITY].) If
the foregoing message appears and operation stops even when you perform
cutting while set to [HEAVY], switch the power off and back on, then press
[SPEED] and set [** cm/s] to a smaller value. (See "7-3 List of Functions.")
The machine is in standby for tool replacement.
If tool replacement is not necessary, then simply press [ENTER].
The [SP COMMAND] menu item should normally be set to [DISABLE].
55