Table of Contents
Advertisement
Step 2 Line up the two elongated holes in the rear of the
emergency stop housing with the two pre-drilled holes
to the front of stand, insert one of the domed Phillips
screw through the housing and while holding it in place
screw on the M4 nut (21) and finger tighten. Repeat for
the opposite side then fully tighten the fixings, see figs
09-10-11.
Step 3 Carefully replace the outer housing and tighten
the four Phillips screws, see fig 12.
Fig 09-10-11-12
Pre-drilled holes
Phillips screw
Elongated hole
24
21
Phillips screw driver
A
Mounting the Table
The saw table can be fitted without removing the blade.
However, if you would feel more comfortable not having
to manoeuvre the table around the blade (the table is
quite heavy), remove the blade by opening the top and
bottom covers, release the tension on the blade by
releasing the Quick release tensioning lever (A), see fig
13-14.
Locate the cast iron table (1) the two M8, clamping knobs
(18) and M8 x 80mm Bolt and Nut (19).
Step 1 Locate the threaded bolt/nut (19), screw the nut
onto the thread then screw the bolt into the pre-drilled
hole in the bandsaw frame, behind the tilt quadrant, see
fig 15.
9
Main Assembly
Fig 13-14
Fig 15
19
Continues Over....
Advertisement
Table of Contents
