Table of Contents
Advertisement
Main Assembly
Fig 32-33-34
5mm Hex key
Step 3 Fit the fence clamp assembly (7) over the front
fence rail (4) and lower the rear of the clamp assembly so
the adjustable guide rests on top of the rear guide rail (5),
see fig 35-36.
Fig 35
Step 4 Locate the M8 nut (16), and screw it onto the
thread of the M8 threaded lever (9) then screw the
threaded lever (9) into the threaded hole in the clamp
assembly (7) mechanism and tighten the nut with a
spanner, see figs 37-38.
Step 5 Slide the fence assembly (7) until it's up against
the blade and press down the locking lever (9), see fig 39.
Look at the 'RED' line on the magnifying glass to check
it's set to '0' on the scale, see fig 40. If it's out of alignment,
7
loosen the front fence rail (4) and tap the side of the
fence until the scale reads '0' then re-secure the fence
rail, see figs 41-42.
4
12
Adjustable guide rest
5
16
9
Spanner
Fig 36
Fig 37-38
7
Advertisement
Table of Contents
